Hi,
I'm trying to launch Butcher 164 installed as WB engine under Arena 3.5, with the command line parameters -ht 32 -par 1, but the engine hangs when out of the GUI book (HS10moves.abk). I red the author's site for the command line parameters, but it's not clear.
I use Windows 7 64, on an Intel I5, and my version of butcher is in theory compliant with 64bit.
Does someone can give me infos to launch this version ?
I tried with an old version, Butcher 158, and it runs without problem.
I think the problem is due to my bad command line parameter.
Arnaud Lohéac
Butcher 164
Moderators: hgm, Rebel, chrisw
-
Dr.Wael Deeb
- Posts: 9773
- Joined: Wed Mar 08, 2006 8:44 pm
- Location: Amman,Jordan
Re: Butcher 164
Try with -ht 128....
works fine here under Windows 7 x64 regards,
Dr.D
works fine here under Windows 7 x64 regards,
Dr.D
_No one can hit as hard as life.But it ain’t about how hard you can hit.It’s about how hard you can get hit and keep moving forward.How much you can take and keep moving forward….
-
Charly
- Posts: 1091
- Joined: Wed Jul 23, 2014 4:30 pm
- Location: Bretagne
Re: Butcher 164
Hi,
First of all, I wish to thank Dr. Wael Deeb and you, Gabor, for the quick and helpfull response.
I made a mix of your two tips and used this engine line command (I knew I made a mistake also with the -par command...)
-ht 128 -par Butcher2CPU 2
Well, it runs perfectly. Now, Butcher 1.64 x64 runs perfectly as a winboard engine under Arena 3.5 !
My test tournament with all the B engines is now ablet to start.
Many thanks !
Arnaud Lohéac
First of all, I wish to thank Dr. Wael Deeb and you, Gabor, for the quick and helpfull response.
I made a mix of your two tips and used this engine line command (I knew I made a mistake also with the -par command...)
-ht 128 -par Butcher2CPU 2
Well, it runs perfectly. Now, Butcher 1.64 x64 runs perfectly as a winboard engine under Arena 3.5 !
My test tournament with all the B engines is now ablet to start.
Many thanks !
Arnaud Lohéac